2C Sensor/ignitor Adapter Kit With 30″ Leads Use With 780 Units

Description

2C Sensor/ignitor Adapter Kit With 30″ Leads Use With 780 Units

Designed as a direct replacement for OEM assemblies this sensor restores full temperature feedback in equipment that relies on precise resistance curve. Built with proven materials the sensor resists vibration and temperature swings common in HVAC duty. Factory tested and ready for service the sensor matches original performance specs so downtime stays minimal. Engineered for seamless compatibility the sensor preserves balance and keeps diagnostics clear. Every unit passes inspection to ensure dimensional tolerances for an effortless fit.

Internal protection cuts power if limits are exceeded guarding downstream components. The form factor lines up with existing brackets and grommets eliminating the need to drill fresh slots. Technicians receive pre terminated leads and hardware so the swap takes minutes with ordinary hand tools. Sealed internals remove routine maintenance letting service crews focus on other call outs. A corrosion resistant finish shields critical surfaces from attic humidity and coastal air.

Specifications
• Sensor type: thermistor
• Resistance: 10 kOhm at 77 F
• Accuracy: plus or minus 1 percent
• Lead length: 36 in
• Connector: JST
• Operating range: minus 40 to 230 F
• Response time: under 5 s
• Housing: epoxy sealed
• Wire gauge: 22 AWG
• Application: supply air sensing Technicians receive pre terminated leads and hardware so the swap takes minutes with ordinary hand tools.

Use this sensor to deliver accurate temperature feedback to smart controls.