The Bard Wall-Mount Air Conditioner is a self contained energy
efficient heating and cooling system, which is designed to offer maximum
indoor comfort at a minimal cost without using valuable indoor floor
space or outside ground space. These units are the ideal products for
versatile applications such as: new construction, modular offices, school
modernization, telecommunication structures, portable structures or
correctional facilities. Factory or field installed accessories are available to
meet specific job requirements.
Engineered Features:
Aluminum Finned Copper Coils
Rifled tubing and enhanced louvered fin
for maximum heat transfer and energy
efficiency.
Quiet Twin Blowers:
Designed to accept full ducted system or
for non-ducted free blow installations.
Air Conditioner Compressor: Scroll Compressors eliminate need or crankcase heater. Standard on all models.
Designed with R-410A (HFC) non-ozone
depleting refrigerant in compliance with
the Montreal protocol and 2010 EPA
requirements.
Liquid Line Filter Drier:
Standard on all units. Protects system
against moisture.
Galvanized 20 Gauge Zinc Coated
Steel Cabinet:
Cleaned, rinsed, sealed and dried before
the polyurethane primer is applied. The
cabinet is handsomely finished with a
baked on textured enamel, which allows
it to withstand 1000 hours of salt spray
tests per ASTM B117-03.
Electric Heat Strips: Features an
automatic limit and thermal cut-off safety control. Heater packages can be
factory or field installed.
Filter Service Door: Separate
service door provides easy access for filter change.
One Inch, Disposable Air Filters: Are
standard equipment. Optional one inch washable filters available and filter racks
permit the addition of 2" pleated filter. Factory or field installed.
Condenser Fan and Motor Shroud
Assembly: Slides out for easy access.
Barometric Fresh Air Damper: Standard
on all units. Allows up to 25% outside fresh air. Optional ventilation packages
available.
Built-in Circuit Breakers: Standard
on all electric heat versions of single (230/208 volt) and three phase (230/208
volt) equipment. Toggle disconnects are standard on all electric heat versions
of three phase (460 volt) equipment.
Top Rain Flashing:
Standard feature on all models.
Slope Top:
Standard feature for water run-off.
Compressor Control Module:
Standard on all units. Built-in off-
delay timer adjustable from 30 seconds
to 5-minutes. 2-minute on-delay if
power interrupt. 120-second bypass
for low pressure control, and both soft
and manual lockouts for high and low
pressure controls.
Alarm output for
alarm relay.
High & Low Pressure Switches are
Auto-Reset:
Standard on all units. Built-in lockout
circuit resets from the room thermostat.
Provides commercial quality protection
to the compressor.
Barometric Fresh Air Damper:
Allows up to 100 CFM of fresh air.
Full Length Mounting Flanges:
Built into cabinet for improved
appearance and easy installation.
Optional Product Features:
Fully Modulating Economizer:
Can be factory or field installed.
Commercial Room Ventilator:
Can be factory or field installed.
Alarm Relay: Dry contacts for remote alarm on high or low pressure lockouts.
Low Ambient Cooling: Permits cooling down to 0°F Ambient Outdoor temps. Field or factory installed option.
[