W30HB-A00 Bard 2.5 Ton Wall Mount Heat Pump | 11eer | 230/1 | No Aux Heat

Description

The Bard Wall-Mount Heat Pump is a self contained energy
efficient heating and cooling system, which is designed to offer maximum
indoor comfort at a minimal cost without using valuable indoor floor
space or outside ground space. These units are the ideal products for
versatile applications such as: new construction, modular offices, school
modernization, telecommunication structures, portable structures or
correctional facilities. Factory or field installed accessories are available to
meet specific job requirements.

Aluminum Finned Copper Coils
Rifled tubing and enhanced louvered fin
for maximum heat transfer and energy
efficiency.

Quiet Twin Blowers:
Designed to accept full ducted system or
for non-ducted free blow installations.

Designed with R-410A (HFC) non-ozone
depleting refrigerant in compliance with
the Montreal protocol and 2010 EPA
requirements.

Liquid Line Filter Drier:
Standard on all units. Protects system
against moisture.

Galvanized 20 Gauge Zinc Coated
Steel Cabinet:
Cleaned, rinsed, sealed and dried before
the polyurethane primer is applied. The
cabinet is handsomely finished with a
baked on textured enamel, which allows
it to withstand 1000 hours of salt spray
tests per ASTM B117-03.

Electric Heat Strips: Features an
automatic limit and thermal cut-off safety control. Heater packages can be
factory or field installed.

 

Filter Service Door: Separate
service door provides easy access for filter change.

 

One Inch, Disposable Air Filters: Are
standard equipment. Optional one inch washable filters available and filter racks
permit the addition of 2″ pleated filter. Factory or field installed.

 

Condenser Fan and Motor Shroud
Assembly: Slides out for easy access.

 

Barometric Fresh Air Damper: Standard
on all units. Allows up to 25% outside fresh air. Optional ventilation packages
available.

 

Built-in Circuit Breakers: Standard
on all electric heat versions of single (230/208 volt) and three phase (230/208
volt) equipment. Toggle disconnects are standard on all electric heat versions
of three phase (460 volt) equipment.

Top Rain Flashing:
Standard feature on all models.

Slope Top:
Standard feature for water run-off.

Compressor Control Module:
Standard on all units. Built-in off-
delay timer adjustable from 30 seconds
to 5-minutes. 2-minute on-delay if
power interrupt. 120-second bypass
for low pressure control, and both soft
and manual lockouts for high and low
pressure controls.

Alarm output for
alarm relay.

High & Low Pressure Switches are
Auto-Reset:
Standard on all units. Built-in lockout
circuit resets from the room thermostat.
Provides commercial quality protection
to the compressor.

Barometric Fresh Air Damper:
Allows up to 100 CFM of fresh air.

Full Length Mounting Flanges:
Built into cabinet for improved
appearance and easy installation.

Fully Modulating Economizer:
Can be factory or field installed.

Commercial Room Ventilator:
Can be factory or field installed.

Alarm Relay: Dry contacts for remote alarm on high or low pressure lockouts.

Low Ambient Cooling: Permits cooling down to 0°F Ambient Outdoor temps.  Field or factory installed option.