W12AB-K00 | Bard 1.0 Ton Wall Mount AC | 11eer | 115 volts | No Heat

Description

The Bard Wall-Mount One Ton Air Conditioner is a self contained energy
efficient heating and cooling system, which is designed to offer maximum
indoor comfort at a minimal cost without using valuable indoor floor
space or outside ground space. The One Ton is the ideal product for
versatile applications such as: new construction, modular offices, school
modernization, telecommunication structures, portable structures or
correctional facilities. Factory or field installed accessories are available to
meet specific job requirements.

Aluminum Finned Copper Coils
Rifled tubing and enhanced louvered fin
for maximum heat transfer and energy
efficiency.

Quiet Twin Blowers:
Designed to accept full ducted system or
for non-ducted free blow installations.

High Efficiency Rotary Compressor
R-410A Refrigerant:

Designed with R-410A (HFC) non-ozone
depleting refrigerant in compliance with
the Montreal protocol and 2010 EPA
requirements.

Liquid Line Filter Drier:
Standard on all units. Protects system
against moisture.

Galvanized 20 Gauge Zinc Coated
Steel Cabinet:
Cleaned, rinsed, sealed and dried before
the polyurethane primer is applied. The
cabinet is handsomely finished with a
baked on textured enamel, which allows
it to withstand 1000 hours of salt spray
tests per ASTM B117-03.

Electrical Components:
Are easily accessible for routine
inspection and maintenance through a
right side, service panel opening.
Circuit Breaker:
Standard on 230/208 Models.

One Inch, Disposable Air Filter:
Easily removed for replacement from
the outside.
Optional two-inch pleated
filter, factory or field installed.

Top Rain Flashing:
Standard feature on all models.

Slope Top:
Standard feature for water run-off.

Compressor Control Module:
Standard on all units. Built-in off-
delay timer adjustable from 30 seconds
to 5-minutes. 2-minute on-delay if
power interrupt. 120-second bypass
for low pressure control, and both soft
and manual lockouts for high and low
pressure controls.

Alarm output for
alarm relay.

High & Low Pressure Switches are
Auto-Reset:
Standard on all units. Built-in lockout
circuit resets from the room thermostat.
Provides commercial quality protection
to the compressor.

Barometric Fresh Air Damper:
Allows up to 100 CFM of fresh air.

Full Length Mounting Flanges:
Built into cabinet for improved
appearance and easy installation.

Fully Modulating Economizer:
Can be factory or field installed.

Commercial Room Ventilator:
Can be factory or field installed.

Alarm Relay: Dry contacts for remote alarm on high or low pressure lockouts.

Low Ambient Cooling: Permits cooling down to 0°F Ambient Outdoor temps.  Field or factory installed option.