Induced Draft Blower w/gasket

Description

Induced Draft Blower w/gasket

Built with proven materials the inducer resists vibration and temperature swings common in HVAC duty. Every unit passes inspection to ensure dimensional tolerances for an effortless fit. Factory tested and ready for service the inducer matches original performance specs so downtime stays minimal. Designed as a direct replacement for OEM assemblies this inducer restores full draft flow in equipment that relies on precise venting. Engineered for seamless compatibility the inducer preserves balance and keeps diagnostics clear.

The form factor lines up with existing brackets and grommets eliminating the need to drill fresh slots. Technicians receive pre terminated leads and hardware so the swap takes minutes with ordinary hand tools. Internal protection cuts power if limits are exceeded guarding downstream components. A corrosion resistant finish shields critical surfaces from attic humidity and coastal air. Sealed internals remove routine maintenance letting service crews focus on other call outs.

Specifications
• Voltage: 115 V
• Motor type: shaded pole
• Rotation: CCW facing shaft
• Wheel diameter: 4.3 in
• Pressure port: 0.25 in barb
• Housing material: coated steel
• Full load current: <= 1 A • Speed setting: single speed • Lead length: 18 in Molex • Thermal protection: automatic reset The form factor lines up with existing brackets and grommets eliminating the need to drill fresh slots. Use this inducer to restore safe combustion draft when the factory unit fails.