115v 1/30 HP 3000 RPM Single Speed Induced Draft Blower W/Gasket (dim 12x12x10)

Description

115v 1/30 HP 3000 RPM Single Speed Induced Draft Blower W/Gasket (dim 12x12x10)

Designed as a direct replacement for OEM assemblies this inducer restores full draft flow in equipment that relies on precise venting. Engineered for seamless compatibility the inducer preserves balance and keeps diagnostics clear. Every unit passes inspection to ensure dimensional tolerances for an effortless fit. Factory tested and ready for service the inducer matches original performance specs so downtime stays minimal. Built with proven materials the inducer resists vibration and temperature swings common in HVAC duty.

Technicians receive pre terminated leads and hardware so the swap takes minutes with ordinary hand tools. Internal protection cuts power if limits are exceeded guarding downstream components. Sealed internals remove routine maintenance letting service crews focus on other call outs. A corrosion resistant finish shields critical surfaces from attic humidity and coastal air. The form factor lines up with existing brackets and grommets eliminating the need to drill fresh slots.

Specifications
• Voltage: 115 V
• Motor type: shaded pole
• Rotation: CCW facing shaft
• Wheel diameter: 4.3 in
• Pressure port: 0.25 in barb
• Housing material: coated steel
• Full load current: <= 1 A • Speed setting: single speed • Lead length: 18 in Molex • Thermal protection: automatic reset A corrosion resistant finish shields critical surfaces from attic humidity and coastal air. Use this inducer to restore safe combustion draft when the factory unit fails.